Unable to Flash the Intel Edison

Question

I am using Intel edison to for the IOT project. I flashed the device and downloaded the image as instructed in the manual flash session. But while trying to flash I am not able to find /dev/cu.usbserial. (Note I use Yosemite 10.10.2 and have installed the relevant FTDI Driver ).

I only see usbmodemfa133(which does not respond to screen)

Answer 1

Best Answer

Answer by priyanky@apigee.com · Oct 31, 2015 at 03:01 PM

Yes I was using the article and image mentioned. I had to restart my PC after FTDI driver install for it to take effect. (Though it is not mentioned in the install instructions of the driver). Anyways that worked

Add comment Show 1 · Link

10 |5000 characters needed characters left characters exceeded

Anil Sagar @ Google ♦♦

· Oct 31, 2015 at 03:12 PM 0

Link

Thank you for sharing same with community @priyanky@apigee.com

Get answers, ideas, and support from the Apigee Community

Unable to Flash the Intel Edison

1 Answer

Your answer

Follow this Question

Related Questions